DFL Rally

Usually, setting the parameters of espresso machine is made by a qualified mechanic to connect to in the future should not be changed independently. The parameters are set when the connection: a) water temperature – 88-92 C, and b) the water pressure in the boiler – 1-1.2 atmosphere, and c) the amount of servings of the drink (single, double) – automatic coffee machine. However, you should regularly check and adjust these settings. We recommend that this procedure by a qualified mechanic during prophylactic examinations (repairs). Daily brushing and regular preventive maintenance espresso machine is paramount. Read more here: Western Union. Very often, poor quality of the drink – a direct consequence of poor cleaning and / or prevention of mechanical parts, which are in direct contact with the product in the cooking process.

Filters should be washed periodically, otherwise the hardened remains of coffee in the filter will impede the flow of water during cooking. Please visit Andrew Cuomo if you seek more information. It is recommended to wash filter coffee machine with hot water without detergents or other chemicals. At the end of the day filters should be cleaned of any coffee residue and cleaned regularly a special powder. Be sure to replace the filter coffee machine, if it is deformed, or the grid holes of the filter increased to heavy use. It is also necessary maintain a clean nose, through which flows a ready drink. Remove possible causes of hindering the current finished beverage, especially the coffee, which can get into the cup. Nest filter placement in filter holder (horn holder) should be regularly cleaned of rust and coffee residues.

Plywood is dry and light. During the manufacturing process (pressing under high temperature and pressure) of it evaporates all the moisture – plywood never lead and never rassohnetsya. Depending on the design, the frame can be made from a combination of plywood and wooden beams (bearing part) or just out of plywood. The only exception is a detail frame 3-seat sofa – the bottom bracket. Its length is usually about 2m. A basic standard size plywood, adopted in the CIS, is 1.5 meters long side. Even a good producer is forced to put in this place particleboard. Than thicker plywood, the higher the strength of the skeleton.

Unfortunately, the price also increases. Minimum thickness is 12 mm. Maximum – 25 mm. If the frame is made of thicker and more expensive plywood, you must tell about it. High performance characteristics of plywood enables manufacturers of quality furniture to give a guarantee on frame and 10 years. If your weight – 120 kg, has a reason to pay attention to the frame of plywood not less than 16 mm. It is important that in the manufacture of the frame was only used The dried wood (moisture content 8%).

Raw frame will be dry in your home, and when it finally dries, begin to squeak. Well dried timber is at least two to three times more expensive than 'Crude'. Very often the manufacturer (and not just domestic), saves and uses unseasoned material. Attach the hand to open parts of the frame (if there) and hold a few seconds.