By dflrally ( December 19, 2017 at 9:11 pm) · Filed under General, construction of life, design and interior
Our website contains comprehensive information about the tree, its products, the properties of wood, its use – in short, all of the parquet of different breeds, its installation and species. Tree species are divided into coniferous and deciduous. Conifers trees make up a large portion of our woods, they grow thick stands (stands). Each has a high straight trunk. These species most widely used in building and woodworking industry. Annual layers in Softwood clearly visible in all sections.
Later part of the annual layers are more or less broad, dark color; medullary rays, small (invisible). The wood of many conifers contains a resin that smells like turpentine. Resin moves on the front section are given bright points in the later part of the annual layers, the radial and tangentalnom cuts – the kind of dark lines (dashes). Conventional hardwood species trees depending on the particular location of vessels in the annual layers are divided into two types – koltsesosudisty and rasseyannososudisty, both widely used in the production of parquet. In koltsesosudistyh species (oak, ash, etc.) large vessels are circular rows in the early part of the annual layer, the rasseyannososudistyh species (birch, beech, etc.), small vessels evenly dispersed across the entire width of the annual layer. Therefore, the annual layers of wood koltsesosudistyh rocks on all the cuts are always different is good, and rasseyannososudistye – badly. Breed growing tree easy to identify the bark, leaves or needles, at a considerable distance – to form the crown. In determining rock beams at a distance watching his features such as shape, color tone of bark and wood.
Permalink
By dflrally ( February 12, 2012 at 11:19 am) · Filed under General, Uncategorized, and Interior Design, construction of life
Application Procedure radiator paints and enamels If you're going to make repairs in the winter when central heating is included, then the first thing you need to make sure – the temperature conditions applied. Many enamels and paints recommended to paint radiators only when the system is off. Without considering this, you risk getting a yellowish coating (if the stain alkyd white enamel) and not very flat and smooth (the paint will dry too quickly and unevenly, and no time to spread evenly). Surfaces must be clean, dry, without a trace of dust or grease. Unpainted radiators should be degreased, lightly treated with sandpaper and remove dust, covered with a layer of anticorrosive primer (primer CS-010) (usually the manufacturers operating instructions for recommended primer, which is best way combined with this paint). If the radiator has been painted previously, but the paint layer is in bad shape (cracked, flaking, etc.) then you should delete it and continue to do both with unpainted radiator.
If an old coat of paint and strong you are not satisfied only by its color or appearance, you should only treat the surface lightly with sandpaper to a state of haze and then wash it in any detergent removing grease and dust. Radiators are painted with a brush, paint the flat radiators comfortable cushion (less likely to use spray gun – it's less convenient) in 1-2 layers. On the wrist, by the way, need to be concerned in advance – depending on on what you have installed the radiator – may be the most convenient brush on a long handle, or, conversely, a small, thick or thin. For painting hard to reach places handy special radiator brush with a curved handle. If you apply two coats of alkyd enamel, after the complete drying of the first layer it is recommended to treat lightly with sandpaper.
Permalink